SecureCRT 7.1 crashes on startup w/Fedora 18 when run by non-root user

[wwinfrey]

When I attempt to launch SecureCRT 7.1 beta 2 on Fedora 18 under my normal UID, I get the following fatal error:

Cannot mix incompatible Qt library (version 0x40804) with this library (version 0x40803)
[1] 3935 abort (core dumped) /usr/local/bin/SecureCRT

However, if I run it via sudo, it works without issue.

7.0.3 runs just fine.

[UPDATE] Perhaps it's because I have the Qt dev tools installed? In the strace dump I ran I did notice a couple queries to ~/.config/Trolltech.conf

[bgagnon]

Hello wwinfrey,

Fedora 18 is not an officially supported operating system.

By v7.0.3 runs just fine, do you mean when using the non-root user account?

Were you able to locate the core dump file?

If so, would you send an e-mail to support@vandyke.com using (or providing) the e-mail address associated with your download account?

I will then provide instructions for you to get the core dump to us.

Please reference "Attn Brenda - Forum Thread #10940" in the subject.

[wwinfrey]

I realize it's not supported. I'm posting this as a courtesy to you guys. Yes, when I say 7.0.3 runs fine I mean it runs fine as a non-root user. I cannot find the core dump as of yet but if I do I will send it to you.

[bgagnon]

Hello wwinfrey,

I understand and we appreciate that.

If found, please do not attach the core dump to e-mail (unless relatively small), but instead let me know the username (e-mail address) associated with your VanDyke Software download account.