(END) Tail on status responses
when i ask the status of servers i have a strange issue:
for example at dovecot:
service dovecot status
i get the answer by the server and at the end:
"lines 1-22/22 (END)"
this is not on other servers, where normally the user name is prompting for next command at the end of the answer like:
the problem is, when i put this last line in the command:
strResult = crt.Screen.ReadString("(END)")
then the proceeding takes really long time,
instead as if i would use the command:
strResult = crt.Screen.ReadString("root@user:~#")
then it is proceeding really fast.
why do i get this "line ... (END)" answer instead of the user prompt for next command?
what can i do that i always receive the user prompt at the end of the answer.
thanks lot for any idea.
forgot to say,
if this (END) statement is at the end of the answer, securecrt does not accept any commands anymore. i have to restart it.
Last edited by mike1950r; 10-01-2018 at 08:01 PM.
It sounds like that's server-side configuration and I'm not sure there's anything SecureCRT can do to change it.
Are you connecting to this server with SSH2 protocol?
If so, it's often useful to see trace options output which provides debugging information that may help us better understand the problem that you're experiencing.
To enable trace options output:
NOTICE: The requested troubleshooting data may include sensitive information (usernames, passwords, publicly-accessible host names or IP addresses, etc.).
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Display Modes||Rate This Thread|