SecureCRT and command line shrinks

[Ezhov Igor]

Hello all,
When i work in my SecureCRT i see only 80 symbols in command line. After 80 symbols command line shrinks to 50 symbols and command line transfer to format "my device# $my next symbols." I would like to see all line without reduction. I rtyed change logical columns in Terminal -> Emulation from 80 to 160 however it is no solved my issue.
Could you help me, please.

[jdev]

Originally Posted by Ezhov Igor

When i work in my SecureCRT i see only 80 symbols in command line. After 80 symbols command line shrinks to 50 symbols and command line transfer to format "my device# $my next symbols." I would like to see all line without reduction. I rtyed change logical columns in Terminal -> Emulation from 80 to 160 however it is no solved my issue.

If you've changed the number of columns in SecureCRT's configuration and you're still seeing the issue, that indicates tell-tale behavior of connecting to certain networking equipment that has a hard-coded terminal width set (in your case, 80 cols wide), and you'll need to refer to the device manufacturer to determine how to increase the number of columns in that device's term config in order to allow the device to handle more. For example, on a Cisco ASA can use terminal width in global config mode to set the number of hard-coded columns.

For assistance with configuring the terminal properties of the device to which you're connected in this scenario, please contact the manufacturer of your connected device.

--Jake

[Ezhov Igor]

Many thanks! Works!