Welcome to the VanDyke Software Forums

Join the discussion today!


Go Back   VanDyke Software Forums > General

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 05-07-2017, 07:23 AM
Haroon Haroon is offline
Registered User
 
Join Date: May 2017
Posts: 1
Send Command on different nodes

Hi,
I have a raw data on excel on daily bases for Cisco IOS nodes to check interfaces are up or down connecting via NCM through SecureCRT eg. connect MBH4-MW144-1 or SSH MBH4-MW144-1.
Sh int des | i Gi**(must match in raw data)

PE-L3Agg-Bal-401-2.stc.com.sa:GigabitEthernet9/2
**Connected to MBH4-MW144-1 GigabitEthernet0/14**
80,400

PE-L3Agg-Bal-401-2.stc.com.sa:GigabitEthernet9/2
**Connected toMBH4-F93R10-1 Gi0/14**
80,400

PE-AggX16-Jiz2-703-41-1:GigabitEthernet1/0/2
*connected to MBH6-719-15-000-1 TenGig0/1-Active* underobserve for Huge broadcast problem
86,400

PE-L3Agg-Krj-130-1.stc.com.sa:TenGigabitEthernet9/3
*connected to MBH6-199-00-000-1 TenGi0/2 *
15,900

SH-Slmn-405-2.stc.com.sa:GigabitEthernet0/0/0
** Connected to PE-Agg22-Slmn-405-4 Gi100/0/0/0**
94.44444

Need to filter MBH4,MBH6 & SH and check the interface status though connecting SecureCRT (connect or SSH) telnet not allowed. Thanks for your support in advance.

BR,
Haroon.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 10:19 PM.