View Single Post
  #1  
Old 05-07-2017, 07:23 AM
Haroon Haroon is offline
Registered User
 
Join Date: May 2017
Posts: 1
Send Command on different nodes

Hi,
I have a raw data on excel on daily bases for Cisco IOS nodes to check interfaces are up or down connecting via NCM through SecureCRT eg. connect MBH4-MW144-1 or SSH MBH4-MW144-1.
Sh int des | i Gi**(must match in raw data)

PE-L3Agg-Bal-401-2.stc.com.sa:GigabitEthernet9/2
**Connected to MBH4-MW144-1 GigabitEthernet0/14**
80,400

PE-L3Agg-Bal-401-2.stc.com.sa:GigabitEthernet9/2
**Connected toMBH4-F93R10-1 Gi0/14**
80,400

PE-AggX16-Jiz2-703-41-1:GigabitEthernet1/0/2
*connected to MBH6-719-15-000-1 TenGig0/1-Active* underobserve for Huge broadcast problem
86,400

PE-L3Agg-Krj-130-1.stc.com.sa:TenGigabitEthernet9/3
*connected to MBH6-199-00-000-1 TenGi0/2 *
15,900

SH-Slmn-405-2.stc.com.sa:GigabitEthernet0/0/0
** Connected to PE-Agg22-Slmn-405-4 Gi100/0/0/0**
94.44444

Need to filter MBH4,MBH6 & SH and check the interface status though connecting SecureCRT (connect or SSH) telnet not allowed. Thanks for your support in advance.

BR,
Haroon.
Reply With Quote