Thread: SecureCRT
View Single Post
  #3  
Old 08-06-2004, 11:04 AM
aLTeReGo's Avatar
aLTeReGo aLTeReGo is offline
Registered User
 
Join Date: Jun 2004
Posts: 8
I hope this is what you were looking for...

SecureCRT - Version 4.1.7 (build 257)
[LOCAL] : RECV : Remote Identifier = "SSH-2.0-OpenSSH_3.6p2-aes"
[LOCAL] : CAP : Remote can re-key
[LOCAL] : CAP : Remote sends language in password change requests
[LOCAL] : CAP : Remote sends algorithm name in PK_OK packets
[LOCAL] : CAP : Remote sends algorithm name in public key packets
[LOCAL] : CAP : Remote sends algorithm name in signatures
[LOCAL] : CAP : Remote sends error text in open failure packets
[LOCAL] : CAP : Remote sends name in service accept packets
[LOCAL] : CAP : Remote includes port number in x11 open packets
[LOCAL] : CAP : Remote uses 160 bit keys for SHA1 MAC
[LOCAL] : CAP : Remote supports new diffie-hellman group exchange messages
[LOCAL] : CAP : Remote correctly handles unknown SFTP extensions
[LOCAL] : CAP : Remote correctly sends UTF8 where UTF8 is specified
[LOCAL] : CAP : Remote correctly encodes OID for gssapi
[LOCAL] : CAP : Remote correctly uses connected addresses in forwarded-tcpip rs
[LOCAL] : CAP : Remote is IETF-DRAFT compliant
[LOCAL] : SEND : KEXINIT
[LOCAL] : RECV : Read kexinit
[LOCAL] : Available Remote Kex Methods = diffie-hellman-group-exchange-sha1,dif1
[LOCAL] : Selected Kex Method = diffie-hellman-group-exchange-sha1
[LOCAL] : Available Remote Host Key Algos = ssh-rsa,ssh-dss
[LOCAL] : Selected Host Key Algo = ssh-dss
[LOCAL] : Available Remote Send Ciphers = aes128-cbc,3des-cbc,blowfish-cbc,caste
[LOCAL] : Selected Send Cipher = aes128-cbc
[LOCAL] : Available Remote Recv Ciphers = aes128-cbc,3des-cbc,blowfish-cbc,caste
[LOCAL] : Selected Recv Cipher = aes128-cbc
[LOCAL] : Available Remote Send Macs = hmac-md5,hmac-sha1,hmac-ripemd160,hmac-r6
[LOCAL] : Selected Send Mac = hmac-md5
[LOCAL] : Available Remote Recv Macs = hmac-md5,hmac-sha1,hmac-ripemd160,hmac-r6
[LOCAL] : Selected Recv Mac = hmac-md5
[LOCAL] : Available Remote Compressors = none,zlib
[LOCAL] : Selected Compressor = none
[LOCAL] : Available Remote Decompressors = none,zlib
[LOCAL] : Selected Decompressor = none
[LOCAL] : SEND : KEXDH_GEX_REQUEST
[LOCAL] : RECV : KEXDH_GEX_GROUP
[LOCAL] : RECV : DH Prime is 1024 bits
[LOCAL] : SEND : KEXDH_INIT
[LOCAL] : RECV : KEXDH_REPLY
[LOCAL] : SEND : NEWKEYS
[LOCAL] : RECV : NEWKEYS
[LOCAL] : SEND: SERVICE_REQUEST[ssh-userauth]
[LOCAL] : RECV: SERVICE_ACCEPT[ssh-userauth] -- OK
[LOCAL] : SENT : USERAUTH_REQUEST [none]
[LOCAL] : RECV : AUTH_SUCCESS
[LOCAL] : SEND: agent forwarding request
[LOCAL] : RECV: TCP/IP close
[LOCAL] : Connected for 5 seconds, 863 bytes sent, 1586 bytes received
Reply With Quote